By rotating the control

SEEK/AMS control

Rotate and release to:

–Skip tracks.

–Tune in stations automatically.

Rotate, hold, and release to:

–Fast-forward/reverse a track.

–Find a station manually.

By pushing in and rotating the control

PRESET control

Push in and rotate the control to:

– Receive preset stations.

Changing the operative direction

The operative direction of controls is factory-set as shown below.

To increase

To decrease

If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction.

Adjusting the sound characteristics

You can adjust the balance, fader, low pass filter and subwoofer volume.

1 Press (SEL) repeatedly until “BAL,” “FAD,” “LPF” or “SUB” appears.

Each time you press (SEL), the item changes as follows:

LOW*1 t MID*1 t HI*1 tBAL (left-right) t FAD (front-rear) t LPF (low pass filter)*2*3 tSUB (subwoofer volume)*2*4

*1 When EQ3 is activated (page 19).

*2 When “SUB” is selected (page 18).

*3 The cut off frequency is adjustable to 78 Hz, 125 Hz or OFF.

*4 The volume level is adjustable between –10 and +10 steps. (Below –10, “ATT” is displayed.)

2 Press the volume +/– button to adjust the selected item.

Note

Adjust within 3 seconds after selecting the item.

Quickly attenuating the sound

Press (ATT).

After “ATT-ON” momentarily appears, “ATT” appears in the display.

To restore the previous volume level, press (ATT) again.

Tip

When the interface cable of a car telephone is connected to the ATT lead, the unit decreases the volume automatically when a telephone call comes in (Telephone ATT function).

Press (SEL) for 2 seconds while

17

pushing the VOL control.