Maintenance
Cleaning the tape heads and tape path
Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. To make the best possible recording, however, we recommend that you clean all surfaces over which tape travels before each recording.
Pinch roller | Erase head |
Record/playback head
Capstan
Cotton swab
After cleaning, insert a tape when the areas cleaned are completely dry.
Demagnetizing the tape heads
After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss. At this time, you should demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine.
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With
with no more than 10% total harmonic distortion in AC operation.
Radio section
Frequency range
FM 87.6 - 108 MHz
AM 530 - 1,710 kHz
Aerials
FM: Telescopic aerial
AM:
Cassette-corder section
Recording system
Approx. 120 s (sec.) with Sony cassette
TYPE I (normal): 100- 8,000 Hz
General
Speaker
Full range: 9.2 cm dia., 4 ohms, cone type (1) Outputs
Earphone jack (minijack)
For 32 ohms impedance earphone Power requirements
120 V AC, 60 Hz
6 V DC, four R20 (size D) batteries Power consumption
AC 6 W
Battery life
FM recording
Sony R20P: | approx. 13 h |
Sony alkaline LR20: | approx. 35 h |
|
|
Tape playback |
|
|
|
Sony R20P: | approx. 7 h |
|
|
Sony alkaline LR20: | approx. 20 h |
|
|
Dimensions
Approx. 289 ⋅ 200 ⋅ 123 mm (w/h/d) (11 1⁄2 ⋅ 7 7⁄8 ⋅ 4 7⁄8 inches) (incl. projecting parts)
Mass
Approx. 2.4 kg (5 lb. 5 oz) (incl. batteries) Supplied accessory
AC power cord (1) Earphone (1)
14
| Design and specifications are subject to change without |
Additional Information | notice. |
