Recording a CD on an MD (continued)

Notes

You cannot pause recording during CD-MD High- Speed Synchro Recording.

If the play mode is set to the Repeat or Shuffle Play, it automatically switches to normal play at step 3 of “Recording a CD on an MD”.

The following items are either inoperative or cannot be used during CD-MD High-Speed Synchro Recording:

Auto Cut function.

Recorded signal monitoring.

Recording a CD on an MD and a tape at the same time

Load the CD you want to record. Then load a blank tape and recordable MD. Press SYNCHRO REC repeatedly until “DUAL SYNC” appears, and then perform step 4 through 6 of “Recording a CD on a tape” (see page 38).

Recording a tape on an

MD

TAPE-MD Synchro Recording

You can make an analog recording of a tape on an MD.

You can use Type I (normal) tape.

1 Load a recordable MD.

2 Load a tape.

3 Press SYNCHRO REC repeatedly until “TAPE-MD SYNC” appears in the display.

4 Press ENTER/START.

The MD deck stands by for recording and the tape deck pauses for play.

Tape playback side

Nappears for the front side, and nfor the reverse side. To play the side not indicated, press TAPE xand remove the tape to reverse the tape side, then perform steps 3 and 4 again.

5 Verify that “Press START” flashes in the display. Then press ENTER/START.

Recording starts.

To stop recording

Press TAPE xor MD x.

Note

If the MD becomes full during recording, the tape deck and the MD deck stop automatically.

18