When the system is connected with a Bluetooth device (when the Bluetooth device name or other information
appears in the system display), press and hold BLUETOOTH OPR on the unit for about 2 seconds to put the system in Bluetooth standby mode.
2Press CLEAR .“DELETE?” appears.3Press ENTER .“COMPLETE” appears and all the pairing information is erased.
Note
In order to connect with a Bluetooth device after performing this operation, you must enter the passcode again.
Playing music of a Bluetooth device
You can operate a Bluetooth device by connecting the system and a Bluetooth device using AVRCP. If the system is not connected with a Bluetooth device using AVRCP, “NOT IN USE” appears when you operate the system.
1 Select the Bluetooth function.Press BLUETOOTH on the unit.
2 Establish a connection from the Bluetooth device.For details about the operations of the Bluetooth device, refer to the operation manual supplied with your Bluetooth device.
Once the connection is established, the system display changes as follows: “CONNECT” Name of the Bluetooth device
3 Start playback.
Press (or BLUETOOTH on the unit) .Depending on the Bluetooth device, you may need to start up the AV software of the Bluetooth device beforehand.
4 Adjust the volume.
Press VOLUME +/(or VOL +/on the unit) .
To check the address of a connected Bluetooth device
Press DISPLAY while the Bluetooth device name appears in the system display.The Bluetooth device address appears for 8 seconds.To cancel the connection with a Bluetooth device
Press and hold BLUETOOTH OPR on the unit for about 2 seconds until “DISCONNCT” appears, or until the information on the display (device name, etc.) disappears.
Other operation
To | Press |
| Pause playback | (or BLUETOOTH |
| on the unit) . |
| Stop playback | . |
| Select a file | /. |
| Find a point in | Hold down / |
| a file | . |
Note
These operations may not be available for certain Bluetooth devices. In addition, the actual operations may differ depending on the connected Bluetooth device.