Setting the Jumpers

Set the jumpers on the rear of the drive in accordance with the configuration of your computer system.

The jumpers are preset at the “MASTER” position as illustrated at the factory.

CSEL

SLAVE

MASTER

Notes for configuration jumpers:

•Designation of the Drive Number is generally set by inserting a jumper pin on either the MASTER or the SLAVE pin.

•When the CRX100E is daisy-chained with a Hard Disk Drive on an IDE Card, set the Hard Disk Drive as MASTER and the CRX100E as SLAVE.

•If the CRX100E is the only device connected to the IDE Card, set the CRX100E as MASTER.

However, it should be noted that some personal computers may use CSEL in lieu of the foresaid MASTER/SLAVE selection. In this case, remove the existing jumpers from MASTER and SLAVE, and set a jumper on CSEL. When the CSEL signal of the interface connector is set low, the drive is designated as Drive 0. When the CSEL is set high, the drive is designated as Drive 1.

Consult your PC manufacturer, IDE Card manufacturer or dealer for further details.

Installing the Drive in Your Computer

11