149US
Additional Information

Reference sections

To clear the memory of the

simple remote control

After removing the batteries, do not use the
remote control for a few minutes.
If the buttons on the receiver or the remote
control do not work due to a malfunction of the
receiver, reboot the receiver.
Hold down ?/1 for 10 seconds.
When the lamp above ?/1 flashes in green, the
reboot starts.
Refer to the following web site for details of
the latest information on the receiver.
http://www.sony.com/essupport

Specifications

AUDIO POWER

SPECIFICATIONS

POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 130 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT1) 2)
Rated Power Output at Stereo Mode
(8ohms 20 Hz – 20kHz,
THD 0.09%):
130W + 130 W
Reference Power Output at Stereo Mode
(4ohms 20 Hz – 20kHz,
THD 0.15%):
130W + 130 W
Reference Power Output
(8ohms 1 kHz, THD 0.7%)
FRONT:
140W + 140 W
CENTER: 140W
SURROUND:
140W + 140 W
SURROUND BACK:
140W + 140 W
Reference Power Output
(4ohms 1 kHz, THD 0.7%)
FRONT:
130W + 130 W
CENTER: 130W
SURROUND:
130W + 130 W
SURROUND BACK:
130W + 130 W
1) Measured under the following conditions:
Power requirements: 120V AC, 60 Hz
2) Depending on the sound field settings and the
source, there may be no sound output.

Clearing the memory

To cle ar See
All memorized settings page48
Memory of the multifunction
remote control
page1 35

Rebooting the receiver

About support information

continued