48US
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to revert back to the factory default
settings.
1Press ?/1 to turn off the
receiver.
2While holding down the TONE

MODE and 2CH/A.DIRECT,

press ?/1 to turn on the

receiver.
3Release the TONE MODE and

2CH/A.DIRECT after a few

seconds.

The “MEMORY CLEARING...” appears
on the display window for a while, then
changes to “MEMORY CLEARED!”
Changes or adjustments made to the
settings are now reset to the defaults.
Note
It takes about one minute for the memory to be
cleared completely. Do not turn the receiver off until
“MEMORY CLEARED!” appears on the display.
Insert two R6 (size-AA) batteries in the
RM-AAL040 remote control, and the
RM-AAU124 remote control.
Observe the correct polarity when installing
batteries.
Notes
•Do not leave the remote control in an extremely hot
or humid place.
•Do not use a new battery with old ones.
•Do not mix manganese batteries and other kinds of
batteries.
•If you do not intend to use th e remote control for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
•When you replace or remove the batterie s, the
programmed codes may be cleared. If this happens,
program the remote control codes again (page 128,
132, 133).

Performing initial setup

operations (clearing all

memorized settings)

?/1
TONE MODE 2CH/A.DIRECT

Inserting batteries into the

remote control

RM-AAL040 RM-AAU124