After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, see page 76. If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this happens, check the speaker connection again.

Note

•Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords are reversed, the sound will lack bass and may be distorted.

Installing the speakers on the wall

1 Prepare screws (not supplied) that are suitable for the hole on the back of each speaker. See the illustrations below.

4 mm (5/ inch)

4.6 mm

32

(3/ inch)

 

 

16

25 mm (1 inch)

10 mm

 

(13/32 inch)

2 Fasten the screws to the wall.The screws should protrude 5 to 7 mm (7/32 to 9/32 inch).

Hole on the back of the speaker

5 to 7 mm

(7/32 to 9/32 inch)

3 Hang the speakers on the screws.

4.6 mm

(3/16 inch)

10 mm

(13/32 inch)

Hole on the back of the speaker

18US