After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, see page 83. If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this happens, check the speaker connection again.

Note

•Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords are reversed, the sound will lack bass and may be distorted.

Installing the speakers on the wall

1 Prepare screws (not supplied) that are suitable for the hole on the back of each speaker. See the illustrations below.

4 mm (5/32 inch)

4.6 mm

Hole on the back of

the speaker

 

(3/ inch)

 

 

16

 

25 mm (1 inch)

10 mm

 

 

(13/32 inch)

 

2 Fasten the screws to the wall.

The screws should protrude 7 to 8 mm (9/32 to 11/32 inch) for the front speakers, 8 to 9 mm (11/32 to 3/8 inch) for the surround speakers.

For the front speakers

For the surround speakers

165mm

(6 1/2 inch)

7 to 8 mm

 

 

 

 

 

 

 

 

 

8 to 9 mm

 

 

 

(9/ to 11/

32

inch)

(11/ to 3/

8

inch)

32

 

32

 

 

3 Peel the seals off the two screw points on the rear of the speaker.

(Front speakers only)

Started Getting

continued

21US