5 Insert your camcorder into the Handycam Station.
6 Slide the POWER switch up to OFF (CHG).
The CHARGE lamp lights up and charging starts.
To charge the battery pack using only the AC Adaptor
DC plug
DC IN jack
Power cord
AC Adaptor
To the wall outlet
You can charge the battery pack on a trip, even if you have not brought the Handycam Station along. With the v mark on the DC plug facing front, connect the AC Adaptor to the DC IN jack on your camcorder as shown in the illustration.
After charging the battery
The CHARGE lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack.
To remove the battery pack
Battery pack
POWER switch
BATT 
(battery release) lever
1Set the POWER switch to OFF (CHG).
2Slide the BATT 
(battery release) lever in the direction of 1 and push it
down in the direction of 2.
Remove the battery pack when it lifts up in the direction of 3.
bNote
•Be careful not to drop the battery pack when you remove the battery pack if your camcorder is in a vertical state.
•Always attach the terminal cover to protect the battery terminal. If you do not use the battery pack for a long time, use up the battery pack completely before storing it. See page 131 about storage of the battery pack.
To check the remaining battery – Battery Info
DISPLAY/BATT INFO
POWER switch
,continued
started Getting
Getting started 17