
For
Connect the power cord (mains lead) to the AC Adaptor and the wall outlet (wall socket).
The CHG (charge) lamp lights up and charging starts.
The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack holding both the DC plug and the Handycam Station (DCR- SR55E/SR65E/SR75E/SR85E) or your camcorder
For
Same as
To remove the battery pack
Turn the POWER switch to OFF (CHG). Slide the BATT (battery) release lever and remove the battery pack.
BATT (battery) release lever
Available running time for the supplied battery pack
Charging time:
Approximate time (min.) required to fully charge a completely exhausted battery pack.
Recording/Playback time:
Approximate time (min.) available when
you use a fully charged battery pack.
|
| (Unit:min.) | |
| |||
| SR45E/SR46E | SR75E/SR85E | |
Charging time | 125 | 125 | |
Recording time |
|
| |
Continuous | 100 | 90 | |
recording | |||
110 | 105 | ||
time | |||
|
| ||
Typical | 50 | 45 | |
recording | |||
50 | 50 | ||
time | |||
|
| ||
Playback time | 120 | 120 | |
140 | 140 | ||
|
Top: When the media is set to the hard disk
Bottom: When the media is set to the “Memory Stick PRO Duo”
Notes
All times measured under the following settings:
Recording mode: [SP]
The LCD backlight turns: [ON]
Typical recording time shows the time when you repeat recording start/stop, turning the power on/off and zooming.
On the battery packBefore changing the battery pack or removing the AC Adaptor from the camcorder, turn
the POWER switch to OFF (CHG) and make sure that the (Movie) lamp/
(Still) lamp (p. 11)/ACCESS lamps (p. 13, 18) is turned off.
The power will not be supplied from the battery as long as the AC Adaptor is connected to the DC IN jack of your camcorder or the Handycam Station
Times measured when using the camcorder at 25°C (77 ˚F) (10°C to 30°C (50 ˚F to 86 ˚F) is recommended).
The available recording and playback time will be shorter when you use your camcorder in low temperatures.
Started Getting
9