To change the date and time

See the “User’s Guide/Troubleshooting” (page 122)

Select [Date/Time setup] in the Setup menu and perform the procedure in step 2-2 to -5.

When turning on the power

Unless you set the clock, “Set date and time?” appears each time the camera is turned on.

To turn off the power

Set the POWER switch to OFF sliding in the arrow direction. Attach the lens cap. After you remove the lens, store the camera with the body cap attached.

Power Save (The camera nearly shuts down if it is not operated)

If you do not operate the camera for about five seconds, the recording mode display on the LCD monitor disappears. Also, if you do not operate the camera for about three minutes, the camera turns to power saving mode and nearly shuts down (Power Save). To cancel the power save, operate the camera, for example, by pressing the shutter button halfway down.

•You can change the time that must elapse to activate the function (the default settings are [5 sec]/[3 min]). t“User’s Guide/Troubleshooting” (page 120)

Changing the language setting

You can change the screen display to show messages in a specified language. To change the language setting, follow the procedure below.

1Press MENU to display the menu.

2Select [ ] t [1] with b/B on the multi-selector.

3Select [ Language] with v/V on the multi-selector, then press the center of the multi- selector.

4Select the desired language with v/V on the multi-selector, then press the center of the multi-selector.

11