To stand the player on its side

1Attach the stand to the screw hole on the side of the player using the supplied screw.

2Place the player on the stand.

Installing the player on the wall

Attach the jack cover (page 23).

Fastening screws are not supplied. You need to determine the appropriate hanging screws and/or other necessary hardware needed to securely and safely fasten the unit to the wall. Placement of the screws should be at the same height and should be 3-1/4 in. (80 mm) apart. The screws or other fasteners should protrude by 7/32 to 1/4 in. (5 to 6 mm). Please be sure you have selected fasteners or screws that will fit in the hanging holes on the bottom of the unit.

3-1/4 in.

7/32 to 1/4 in.

Notes

•Use the supplied stand only when you use the player in an upright position. Do not attach the stand when you use the player laid flat.

•To move the player, hold the player itself. If you hold the stand, it may break.

•Do not use the player in an upright position without attaching the stand. If you do not attach it, the player will be unstable and may fall over.

Remove the seals covering the hanging holes. Hang the player on the screws. Push the player tightly against the wall.

3/16 in.

3/8 in.

Note

WHEN YOU DISCONNECT OR CONNECT THE CORDS, TAKE THE PLAYER DOWN FROM THE WALL.

24