2 Press C/c to select (SUR-ROUND), then press ENTER repeatedly to select one of the TVS sounds.

Refer to the following explanations given for each item.

•TVS DYNAMIC

•TVS WIDE

•TVS NIGHT

•TVS STANDARD

TVS DYNAMIC

To cancel the setting

Select “OFF” in Step 2.

To turn off the Control Bar

Press DISPLAY repeatedly until the Control Bar is turned off.

◆TVS DYNAMIC

Creates virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers (shown below).

This mode is effective when the distance between the front L and R speakers is short, such as with built-in speakers on a stereo TV.

TV

◆TVS WIDE

Creates virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers. The virtual speakers are reproduced as shown in the illustration below.

This mode is effective when the distance between the front L and R speakers is short, such as with built-in speakers on a stereo TV.

TV

◆TVS NIGHT

Large sounds, such as explosions, are suppressed, but the quieter sounds are unaffected. This feature is useful when you want to hear the dialog and enjoy the surround sound effects of “TVS WIDE” at low volume.

◆TVS STANDARD

Creates virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers. The virtual speakers are reproduced as shown in the illustration below. Use this setting when you want to use TVS with 2 separate speakers.

LR

L : Front speaker (left)

R : Front speaker (right) : Virtual speaker

zHint

You can also change the setting by pressing SUR (or SURROUND on the player) repeatedly.

Notes

•When the playing signal does not contain a signal for the rear speakers, the surround effects will be difficult to hear.

•When you select one of the TVS modes, turn off the surround setting of the connected TV or amplifier (receiver).

•Make sure that your listening position is between and at an equal distance from your speakers, and that the speakers are located in similar surroundings.

46