Adjusting the speaker volume

1While you stop playback, select “SPEAKER SETUP” after pressing SET UP.

2Select “TEST TONE” and set “TEST TONE” to “ON.”

You will hear the test tone from each speaker in sequence.

3From your listening position, select “BALANCE” or “LEVEL” and adjust the value of “BALANCE” and “LEVEL” using >/..

During this adjustment, the test tone is emitted from both speakers simultaneously.

4Select “TEST TONE” and set “TEST TONE” to “OFF” to turn off the test tone.

Controlling the TV or the AV Receiver (Amplifier) with the Supplied Remote

Z

If you adjust the remote signal, you can control your TV with the supplied remote. Default setting is to control Sony TVs with the gmark.

When you connect the player to a Sony AV receiver (amplifier), you can also set the input of the receiver (amplifier) to this player with the supplied remote.

TV/DISC EXPLORER/

 

 

 

1/u (POWER)

DVD switch

 

 

 

 

 

 

 

Number buttons

1

2

3

 

4

5

6

 

 

7

8

9

 

 

 

0

 

 

 

A

B

C D

ALL

 

 

 

DVD

CD

Controlling TVs with the remote

1Slide the TV/DISC EXPLORER/DVD switch to TV.

2Hold down 1/u(POWER), and enter your TV’s manufacturer’s code (see the table on the next page) using the number buttons. Then release 1/u

(POWER).

Code numbers of controllable TVs

If more than one code number is listed, try entering them one at a time until you find the one that works with your TV.

Notes

If you enter a new code number, the code number previously entered will be erased.

When you replace the batteries of the remote commander, the code number may reset to 01 (Sony). Reset the appropriate code number.

Adjustments and Settings

67