mSWITCHER GPI (Switcher General Purpose
Interface) connector
Connect to external devices for input and output of trigger signals. Up to eight inputs and eight outputs are possible, with input and output conditions set on the center control panel.
nTERMINAL connector
oU (signal ground) terminal Connect to the system ground.
p- AC IN (AC power input) A, B, C, D connectors
Connect to 100 to 240 V AC power supply with the optional AC power cords.
Depending on the system’s configuration when shipped, there may be no optional
Caution
For information about installing an
qOUTPUTS 1 to 48 connectors (BNC type)
These connectors output serial digital signals. They can be freely assigned to program output, preview output, AUX output and so on.
There are two BNC connectors for the lower numbers on each slot (1 to 4, 13 to 16, 25 to 28, 37 to 40) and one BNC connector for the upper numbers (5 to 12, 17 to 24, 29 to 36, 41 to 48).
Make output assignments using the center control panel of the
The number of connectors varies depending on the number of
Refer to the User’s Guide for information about signals that may be assigned.
rPRIMARY INPUTS 1 to 68 connectors (BNC type)
These connector accept up to 68 serial digital video signal inputs. The number of connectors varies depending on the number of
sEXTEND INPUTS 69 to 80 connectors (BNC type)
These connectors accept up to 12 expansion serial digital video signal inputs.
Use these connectors when 69 or more inputs are required.
tMONITOR OUTPUTS 49 to 56 connectors
(BNC type)
Use these connectors as outputs for primary input monitors or as auxiliary outputs for external devices.
These connectors are effective if you wish to output primary inputs with as little delay as possible.
10 Location and Function of Parts