Troubleshooting
If you experience any of the following difficulties while using your Network Walkman, use this troubleshooting guide to help you to remedy the problem prior to consult a Sony dealer. Should any problem persist, consult your nearest Sony dealer. If a problem occurs while connected to your computer, also refer to “Troubleshooting” in the online help of the supplied software.
To reset the player
If your Network Walkman does not operate normally, or if there is no sound, even after checking the troubleshooting guide below, remove the battery and
What happened?
On operating| Symptom | Cause/Remedy |
There is no sound. | • The volume level is set to zero. |
Noise is generated. | c Turn the volume up (page 14). |
| • The headphone jack is not connected properly. |
| c Connect the headphone jack properly (page 14). |
| • The headphone plug is dirty. |
| c Clean the headphone plug with a soft dry cloth. |
| • No audio files are stored in the memory. |
| c If “NO DATA” is displayed, transfer audio file(s) from the |
| computer. |
Buttons do not work. | • The GROUP/HOLD switch is set to HOLD. |
| c Set the GROUP/HOLD switch to (NORMAL) (page 25). |
| • Your Network Walkman contains moisture condensation. |
| c Leave your Network Walkman aside for a few hours. |
| • The remaining battery power is insufficient. |
| c Replace the battery (page 9). |
The volume is not loud | The AVLS is enabled. |
enough. | c Disable the AVLS (page 27). |
|
|
There is no sound from the | The headphone jack is not fully inserted. |
right channel of the | c Connect the headphone jack fully (page 14). |
headphones. |
|
|
|
Playback has stopped | The remaining battery power is insufficient. |
suddenly. | c Replace the battery (page 9). |
continued
35