4
Setup
1Connecting your monitor to your computer
Connecting to a Macintosh or compatible
computer
When connecting this monitor to a Macintosh computer, use the
Macintosh adapter (not supplied) if necessary. Connect the
Macintosh adapter to the computer before connecting the cable.
The pin assignment of the HD 15 video signal cable
* DDC (Display Data Channel) is a standard of VESA.
2Turning on the monitor and computer
1Connect the power cord to the monitor and press the
1 (power) switch to turn on the monitor.
2Turn on the computer.
No need for specific drivers
This monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your PC after connecting the mon itor, the setup
Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that you
can use this monitor.
Notes
•Do not touch the pins of the video signal cable connector.
•Check the alignment of the HD15 connector to prevent bending the pins
of the video signal cable connector.
Adjustments

Navigating the menu

1Press the center of the joystick to display the main
menu.
2Move the joystick m/M to highlight the main menu that
you want to adjust and press the center of the joystick.
3Move the joystick m/M to highlight the submenu that
you want to adjust. Then move the joystick </, to
make adjustments.

Adjusting the brightness and contrast

Brightness and contrast adjustments are made using a separate
BRIGHTNESS/CONTRAST menu. These adjustments are
effective for all input signals.
1Move the joystick in any direction to display the
BRIGHTNESS/CONTRAST menu.
2Move the joystick m/M to adjust the brightness ( ),
and </, to adjust the contrast ( ).
Note
If you set the brightness and contrast level to “0”, the picture will black out
and no picture will appear.
Video signal cable
of the monitor to HD15 of the
connecting computer
5432
1
678910
11 12 13 14 15
Pin No. Signal
1Red
2Green (Sync on
Green)
3Blue
4 ID (Ground)
5 DDC Ground*
6 Red Ground
7 Green Ground
8 Blue Ground
9 DDC HOST 5V*
10 Ground
11 ID (Ground)
12 Bi-Directional
Data (SDA)*
13 H. Sync
14 V. Sync
15 Data Clock
(SCL)*
Pin No. Signal
,
60.0kHz/ 75Hz
1024 768
the horizontal
and vertical
frequencies
of the current
input signal
the resolution of the current
input signal (only if the signal
matches to one of the
recommended VESA timing
modes).
Main menu
,,
Sub menu
26
SIZE/CENTER
26 26
BRIGHTNESS/ CONTRAST