Sony HT-1700D About This Manual, Demonstration Mode, For RM-PP411 HT-6500DP and HT-5500D only

About This Manual

The instructions in this manual are for models HT-6500DP, HT-5500D and HT-1700D. Check your model number by looking at the lower right corner of the front panel. In this manual, the STR-K840P is used for illustration purpose unless stated otherwise. Any difference in operation is clearly indicated in the text, for example, “HT-6500DP only”.

The HT-6500DP consists of:
– Receiver	STR-K840P
– Speaker system
• Front/surround speakers	SS-MSP2
• Center speaker	SS-CNP2
• Sub woofer	SA-WMSP4
– DVD player	DVP-NC655P
The HT-5500D consists of:
– Receiver	STR-K840P
– Speaker system
• Front/surround speakers	SS-MSP2
• Center speaker	SS-CNP2
• Sub woofer	SA-WMSP4
– DVD player	DVP-NC615
The HT-1700D consists of:
– Receiver	STR-K740P
– Speaker system
• Front/surround speakers	SS-MSP2
• Center speaker	SS-CNP2
• Sub woofer	SA-WMSP4
– DVD player	DVP-NS315

About area codes

The area code of the receiver you purchased is shown on the lower portion of the rear panel (see the illustration below).

	IMPEDANCE USE 8 – 16Ω
	ENTER		FRONT
		R		L
		R		L
					4-XXX-XXX-XX AA
					Area code
	Any differences in operation, according to the
	area code, are clearly indicated in the text, for
	example, “Models of area code AA only”.
	Tip
	The instructions in this manual describe the controls
	on the receiver. You can also use the controls on the
	supplied remote if they have the same or similar
	names as those on the receiver. For details on the use
	of your remote, see pages 37 – 43 for RM-PP411
	(HT-6500DP and HT-5500D only) and pages 44 – 47
	for RM-U306 (HT-1700D only). For details on the
	use of your DVD player, refer to the separate
4US	operating instructions supplied with the DVD player.

Note for the supplied remote

For RM-PP411 (HT-6500DP and HT-5500D only)

The VIDEO 3, TV/SAT, PHONO, AUX,

SOURCE, MPX/DUAL, ANALOG DIRECT, 12 and ON SCREEN buttons on the remote are not available.

For RM-U306 (HT-1700D only)

The MULTI CH button on the remote is not available.

Demonstration Mode

The demonstration will activate the first time you turn on the power. When the demonstration starts, the following message appears in the display:

“NOW DEMONSTRATION MODE IF YOU FINISH DEMONSTRATION PLEASE PRESS POWER KEY WHILE THIS MESSAGE APPEARS IN THE DISPLAY THANK YOU”

To cancel the demonstration

Press ?/1 to turn the receiver off while the above message is being displayed. The next time you turn the receiver on, the demonstration will not appear.

To view the demonstration

Hold down SET UP and press ?/1 to turn on the power.

Notes

•Running the demonstration will clear the receiver’s memory. For details on what will be cleared, see “Clearing the receiver's memory” on page 15.

•There will be no sound when the demonstration mode is activated.

•You cannot cancel demonstration if you did not press ?/1 while the above message is being displayed. To cancel demonstration after the above message appears, press ?/1 twice to activate the demonstration again. Then, press ?/1 while the above message is being displayed.