56GB
1Press TUNER repeatedly to
select the FM or AM band.
2Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display, select monaural audio
so that the sound will be less distorted.
Press FM MODE repeatedly until the “FM
MONO” appears on the display.
To return to stereo mode, press FM MODE
repeatedly until the “FM AUTO” appears on
the display.
Enter the frequency of a station directly by
using the numeric buttons.
1Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2Press D.TUNING.
3Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Press 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Press 1 b 3 b 5 b 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
4Press ENTER.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
(Except for models of area code EA
only)
You can change the AM tuning scale to either
9 kHz or 10 kHz.
1Press TUNER repeatedly to
select AM.
2Press AMP MENU.
“1-LEVEL” appears on the display.
3Press V/v repeatedly to select
“4-TUNER”.
4Press or b to enter the
menu.
5Press V/v repeatedly to select
“AM STEP”.
6Press or b to enter the
parameter.