Additional Information

Precautions

On safety

Should any solid object or liquid fall into the cabinet, unplug the amplifier and have it checked by qualified personnel before operating it any further.

On power sources

Before operating the unit, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the amplifier.

The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the amplifier itself has been turned off.

If you are not going to use the amplifier for a long time, be sure to disconnect the amplifier from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord.

AC power cord must be changed only at the qualified service shop.

On heat buildup

Although the unit heats up during operation, this is not a malfunction. If you continuously use this unit at a large volume, the cabinet temperature of the top, side and bottom rises considerably. To avoid burning yourself, do not touch the cabinet.

On placement

Place the amplifier in a location with adequate ventilation to prevent heat buildup and prolong the life of the amplifier.

Do not place the amplifier near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.

Do not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions.

Use caution when placing the unit or speakers on surfaces that have been specially treated (with wax, oil, polish, etc.) as staining or discoloraion of the surface may result.

On operation

Before connecting other components, be sure to turn off and unplug the amplifier.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.

If you have any question or problem concerning your amplifier, please consult your nearest Sony dealer.

Troubleshooting

If you experience any of the following difficulties while using the amplifier, use this troubleshooting guide to help you remedy the problem. Also, see “Checking the connections” on page 18 to verify that the connections are correct. Should any problem persist, consult your nearest Sony dealer.

There is no sound no matter which component is selected.

Check that both the amplifier and all components are turned on.

Check that the MASTER VOLUME control is not set at “MIN”.

Check that all speaker cords are connected correctly.

Press MUTING to cancel the muting function.

Check that the headphones are not connected to the PHONES jack. No sound will come from the speakers if the headphones are connected.

Check that the amplifier is not in “Demonstration Mode” (see page 2).

There is no sound from a specific component.

Check that the component is connected correctly to the audio input jacks for that component.

Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the amplifier and the component.

continued

Operations/Additional Other Information

25