6Use test flash to check the flash.

•The test flash method differs depending on the camera used. For details, see the operation instructions of your camera.

•If the test flash does not work, change the position of the camera, flash or subject.

7Check again that the built-in flash and the flash are fully charged, and press the shutter button to take the photo.

Changing the channel setting

If another wireless flash is being used nearby, such as at a photo session, your flash may be set off by the light signal from the built-in flash of another camera. To prevent this, you can change the channel as follows.

1Make sure that the wireless flash lamps “CH1” and “CH2“ are both off.

•If they are on, press the wireless flash button to turn them off.

2Press the wireless flash button for three seconds.

•After three seconds the channel is changed, and the channel indicator lamp changes accordingly.

3Attach the flash to the camera and press the shutter button partway down.

•This operation transmits the channel information from the flash to the camera.

Applications

Continued on the next page

33