42 Chapter 2 Playback and Recording
Chapter 2 Playback and Recording
MARKER BURN
The unit can output to each video jacks and display 4:3
screen marker on the 16:9 screen images. In case of
making an editing tape from the original tape,
[MARKER BURN] can be used.

To set up MARKER BURN

Set [MARKER BURN] in [DISPLAY SET] menu to
[ON].
Notes
•MARKER BURN is effective under the following
conditions.
– While playing back a tape in HDV or an HDV
signal is input via HDV/DV jack, and [DOWN
CONVERT] of [VIDEO OUT] in [IN/OUT REC]
menu is set to [SQUEEZE] or [LETTER BOX].
– When wide signals recorded in DVCAM or DV
format are played back, or wide screen HDV/
DVCAM/DV signals are input to each VIDEO
jacks.
•When [DOWN CONVERT] of [VIDEO OUT] in
[IN/OUT REC] is set to [EDGE CROP], the marker
can not be displayed.
•The markers displayed with EDGE CROP and
MARKER BURN show the available horizontal ratio
range of the 4:3 screen to be cropped. The
displayable image size of the standard 4:3 TV
monitor may appear smaller than the size marked on
the monitor of the unit.
•When the EDGE CROP MARKER and MARKER
BURN are enabled at the same time, the EDGE
CROP MARKER is displayed as priority.
• When you set [MARKER BURN] and [ALLSCAN
MODE] in [DISPLAY SET] menu to [ON] at the
same time, the marker will not appear in the correct
position on LCD monitor. This is not a malfunction.
The marker will be output correctly via each video
jack.
Playback