Troubleshooting (continued)
Error Messages of the IC Recorder
Error message | Cause/Remedy |
“ERR ACCESS“ •The IC recorder failed in memory access. Remove and then insert the batteries.
“ERR DATA“ •The file is not supported by the “Digital Voice Editor” software, or the file itself is corrupted.
“FULL” •The remaining memory of the IC recorder is too small. Erase some messages before recording (page 35).
•When there are already 99 messages in the selected folder or the remaining memory of the IC recorder is short, you cannot divide a message. Erase some messages before dividing a message (page 35).
“LO BATT“ •Batteries are weak. Replace batteries with new ones.
“NO DATA“ •The selected folder does not have any messages. You cannot set the alarm, etc. because of this.
“NO ERASE” •You cannot combine messages of different modes.
“PRE SET” •You set the alarm to play back a message at a date and time previously set on another message. Change the alarm setting.
“SET DATE” •If you do not set date and time, you cannot make alarm or time recording setting. To set date and time, see page 8.
For the error messages of the “Digital Voice Editor”, please refer to the online Help files.