“FILE FULL” is displayed and you cannot operate the IC recorder.
99 messages have been recorded in the selected
folder or 495 messages (when there are 5 folders) in total have been recorded. Therefore you cannot record another message, or move a message. Erase some of the messages (page 31) or erase all the messages after you store them on your computer.
Recording is interrupted. | The VOR function (page 21) is activated. Set “VOR” to “OFF” in | |
|
| the menu (page 37). |
|
| |
Noise is heard. | An object, such as your finger, etc., accidentally rubbed or | |
|
| scratched the IC recorder during recording so that noise was |
|
| recorded. |
|
| The IC recorder was placed near an AC power source, a |
|
| fluorescent lamp or a mobile phone during recording or |
|
| playback. |
|
| Plug of the connected microphone was dirty when recording. |
|
| Clean the plug. |
|
| The (headphones) plug is dirty. Clean the plug. |
|
| |
Recording level is low. | “MIC SENS” (microphone sensitivity) is set to “LOW (L)”. | |
|
| Display the menu and set “MIC SENS” to “HIGH (H)” (page 37). |
|
| |
When recording from | Connect the headphone jack of other equipment to the | |
other equipment, the | (microphone) jack of the IC recorder and adjust the volume | |
input level is too strong or | level on the equipment connected to the IC recorder. | |
not strong enough. |
| |
Playback speed is too fast | The playback speed is adjusted in DPC. Slide the DPC switch to | |
or too slow. | “OFF” or display the menu and adjust the speed in DPC again | |
|
| |
|
|
|
“ | You have not set the clock (page 15). | |
|
|
|
“ | The date of recording will not be displayed if you recorded the | |
displayed on the REC | message when the clock was not set. | |
DATE display. |
| |
|
|
|
Troubleshooting