10GB
To use 3D Glasses
Before use: Remove the battery’s insulating sheet before using the product for the first time.
Parts and components
1Slide switch
Set the switch for a comfortable fit. Set
both the switches on either side for a
comfortable fit. Close the temple frames
slightly inwards to set the switch.
2Battery cover
Detach the cover when replacing the
battery.
3LED indicator
Flashes one time every 3 seconds: Power
on
Flashes three times every 3 seconds: Low
battery. Battery capacity is almost running
out.
Flashes three times: Power off
4IR sensor
Receive signals from the 3D Sync
Transmitter.
IR’s entry angle differs according to
distance or usage environment.
~
•Please keep this face clean.
5Power button
Power on: Press once
Power off: Hold power button down for 2
seconds
* Auto power off: More than 5 minutes without
IR signal
6Nose pad
Adjust the nose pad for a comfortable fit.
7Temple frames
You can bend (adjust) the temple frames
for a comfortable fit.
Pouch (2)
3D Glasses (2)
Increases the width
of the glasses
Decreases the width
of the glasses
This part receives IR
(infrared rays) from the
3D Sync Transmitter.