4 GB
Start-up Guide1: Checking the accessoriesTable-Top Stand (1)
Screws for stand (4 + 3) (for KDL-40/32NX520 (8))
Remote RM-ED046 (1)
Size AA batteries (2)
To insert batteries into the remote
~• Observe the correct polarity when inserting batteries.
• Do not use different types of batteries together or mix
old and new batteries.
• Dispose of batteries in an environmentally friendly way.
Certain regions may regulate the disposal of batteries.
Please consult your local authority.
• Handle the remote with care. Do not drop or step on it,
or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat source,
a place subject to direct sunlight, or a damp room.
2: Attaching the stand~ • For best picture quality, do not expose the screen to
direct illumination or sunlight.
• If the TV is brought directly from a cold to a warm
location, or is placed in a very damp room, or is placed
in a room in which heating has just been turned on,
moisture may condense on the surface or inside the TV.
Should this occur, turn off the TV and leave the TV off
until the moisture evaporates, and then the TV can be
used. If you notice moisture condensation between the
glass panel and the LCD, turn on the TV and the
condensation will evaporate after the TV has warmed
up.
Follow the assembling steps required to place on a
TV stand.
1Refer to the supplied Table-Top Stand
leaflet for proper attachment for some TV
models.
2Place the TV set on the stand. Take care
not to interfere with cables.
3Fix the TV to the stand according to the
arrow marks that guide the screw
holes using the supplied screws.
~
• If using an electric screwdriver, set the tightening torque
at approximately 1.5 N·m (15 kgf·cm).
Push to open