Manual Programme Preset

Before selecting “Label”/“AFT”/“LNA”/“Audio Filter”/“Skip”/“Decoder”, press PROG +/- to select the programme number with the channel. You cannot select a programme number that is set to “Skip” (page 35).

Programme/System/Channel

Presets programme channels manually.

1Press F/f to select “Programme”, then press .

2Press F/f to select the programme number you want to manually tune (if tuning a VCR, select channel 00), then press RETURN.

3Press F/f to select “System”, then press .

4Press F/f to select one of the following TV broadcast systems, then press RETURN.

B/G: For western European countries/regions

I:For the United Kingdom

D/K: For eastern European countries/regions

L:For France

5Press F/f to select “Channel”, then press .

6Press F/f to select “S” (for cable channels) or “C” (for terrestrial channels), then press g.

~

“S” is not available when “United Kingdom” is selected for “Country” (page 6).

7Tune the channels as follows:

If you do not know the channel number (frequency)

Press F/f to search for the next available channel. When a channel has been found, the search will stop. To continue searching, press F/f.

If you know the channel number (frequency)

Press the number buttons to enter the channel number of the broadcast you want or your VCR channel number.

8Press to jump to “Confirm”, then press .

9Press f to select “OK”, then press .

Repeat the procedure above to preset other channels manually.

Label

Assigns a name of your choice, up to five letters or numbers, to the selected channel. This name will be displayed briefly on the screen when the channel is selected.

To input characters, follow steps 2 to 4 of “Programme Labels” (page 33).

AFT

Allows you to fine-tune the selected programme number manually if you feel that a slight tuning adjustment will improve the picture quality.

You can adjust the fine tuning over a range of -15 to +15. When “On” is selected, the fine tuning is performed automatically.

LNA

Improves the picture quality for individual channels in the case of very weak broadcast signals (noisy picture).

If you cannot see any improvement in the picture quality even if you set to “On”, set this option to “Off” (factory setting).

Audio Filter

Improves the sound for individual channels in the case of distortion in mono broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or intermittent sound muting when watching mono programmes.

If you do not experience any sound distortion, we recommend that you leave this option set to the factory setting “Off”.

~

You cannot receive stereo or dual sound when “Low” or “High” is selected.

34 GB