5:Performing the initial setup

4 Press F/f to select the country/region in which you will operate the TV, then press .

If the country/region which you want to use on the TV does not appear in the list, select “-” instead of a country/region.

3,4,6,7

9

Selecting the language and country/ region

1 Connect the TV to your mains socket

(220-240 V AC, 50 Hz).

2 Press 1 on the top edge of the TV.

When you turn on the TV for the first time, the Language menu appears on the screen.

3 Press F/f/G/g to select the language displayed on the menu screens, then press .

Auto tuning the TV

5 Before you start auto tuning the TV, insert

apre-recorded tape into the VCR connected to the TV (page 5) and start play back.

The video channel will be located and stored on the TV during auto tuning.

If no VCR is connected to the TV, skip this step.

6 Press G/g to select “OK”, then press .

7 Press F/f to select “Antenna” or “Cable”, then press .

If you select “Cable”, the screen for selecting the scan type appears. See “To tune the TV for digital cable connection” on page 7.

The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not press any buttons on the TV or remote while proceeding.

If a message appears for you to confirm the aerial connection

No digital or analogue channels were found. Check all the aerial connections and press to start auto tuning again.

8 When the Programme Sorting menu appears on the screen, follow the steps of “Programme Sorting” on page 33.

If you do not wish to change the order in which the analogue channels are stored on the TV, go to next step.

6 GB