Current input signal frequency when the RGB signal* is input

To turn off the monitor

Press 1/uon the remote control. The monitor enters standby mode and the STANDBY indicator lights up. To turn off the main power, press uswitch on the monitor.

Note

To protect the lamp, the picture and sound will not turn on immediately if you try to turn on the power more than 5 seconds after the power has been turned off. If you turn the monitor back on within about 5 seconds after power-off, the picture and sound will reappear immediately.

Muting the sound

Press MUTING on the remote control. “MUTING” appears on the screen.

To restore the sound, press MUTING again, or press VOL+.

Displaying on-screen information

Press DISPLAY on the remote control to display the following information on the screen.

Current input RGB 1 signal

fH: 37.5kHz

fV: 75Hz

*fH: Horizontal frequency fV: Vertical frequency

“OUT OF SCAN RANGE” appears if the scanning frequency range is not within the acceptable limits. (See page 9.)

To make the on-screen information disappear, press DISPLAY again.

Adjusting the computer picture

Adjusting the position (CENTER)

After projecting the picture from a computer, you may need to adjust the position of the picture to fit the monitor screen. You can also move the picture as you like. The setting is only for the input signal displayed on the screen.

 

MENU

ENTER

 

1

Press MENU.

 

 

 

 

MENU

 

2

Press vor Vto select “

(CENTER),” and

 

press ENTER.

 

 

 

 

 

C E N T E R

 

 

ENTER

 

 

 

 

EX I T

3 Press v, V, Bor bto adjust the position. For horizontal adjustment press Bor b.

b: to move the picture right

B: to move the picture left

For vertical adjustment press vor V.

V: to move the picture up

v: to move the picture down

16-GB Operations