Eliminating flickering or blurring (DOT
ADJUST)
MENUENTER
If a part of the screen is flickering or blurring, adjust PITCH and PHASE in the DOT ADJUST menu.
1 Load the Utility Disk (supplied) into your computer.
2 Press MENU.
MENU
3 | Press vor Vto select “ | (DOT ADJUST),” |
|
| and press ENTER. |
|
|
|
| DOT ADJUST |
|
|
| PHASE | 7 |
| ENTER | PITCH | 0 |
| TIMING | YES | |
|
| EXI T |
|
4 | Press vor Vto select PITCH, and press |
| |
| ENTER. |
|
|
The PITCH adjustment screen appears.
ENTER
PITCH |
| – 6 |
5 Press v, V, Bor buntil the lines on the screen become uniform.
Adjust the vertical lines on the screen so that they are evenly spaced.
6 Press ENTER.
The DOT ADJUST menu appears.
If notches in the vertical lines or horizontal noise is observed over the entire screen, adjust PHASE in the next step.
ENTER
7 Press vor Vto select PHASE, and press
ENTER.
The PHASE adjustment screen appears.
ENTER
PHASE
7
8 Press v, V, Bor buntil the screen becomes uniform.
Adjust to diminish the notches in the vertical lines or the horizontal noise on the picture.
Using the Utility Disk
The supplied Utility Disk contains test patterns for PITCH and PHASE adjustments. These test patterns will help you confirm that your adjustments are correct.
If TIMING is set to NO in the DOT ADJUST menu
1Press vor Vto select TIMING, and press ENTER. The TIMING adjustment screen appears.
2Press v, V, Bor buntil TIMING is set to YES.
The PITCH, PHASE or TIMING adjustment screen automatically disappears after about 80 seconds if you do not press any button.
You can also erase the screen by pressing MENU again.
Note
You cannot use this function for the input from VIDEO 1/2/3 IN and COMPONENT IN.