Problem | Possible solution | |
|
| |
Stripe noise during playback/recording | • Video head interference. Keep your VCR away from the TV. | |
of a VCR. | • | Leave a space of 30 cm between your VCR and the TV set to avoid |
|
| noise. |
| • | Avoid installing your VCR in front or at the side of the TV set. |
Poor or no picture (screen is dark), but good sound.
•Using the menu system, select the “Picture Adjustment” menu and select “Reset” to return to the factory settings (page 19).
Noisy picture when viewing a TV channel.
•Using the menu system, select the “Manual Programme Preset” option in the “Set Up” menu and adjust Fine Tuning (AFT) to obtain better picture reception (page 26).
•Using the menu system, set the "Noise Reduction" option in the “Picture Adjustment” menu to reduce the noise in the picture (page 19).
| Distorted picture when changing | • Turn off any equipment connected to the Scart connector on the rear | |
| programmes or selecting teletext. | of the TV set. | |
|
| ||
Cannot operate the menu | • If the item you want to select appears in a pale colour is because you | ||
|
|
| cannot select it. |
|
|
| |
| Wrong characters appear when viewing | • Using the menu system, enter the “Country” option in the “Set Up” | |
| teletext | menu and select the country in which you operate the TV set (page | |
|
|
| 23). |
|
|
|
|
| No sound/Noisy sound |
| |
|
| Good picture, no sound. | • Press the 2 +/- or % (mute) on the remote control. |
|
|
| • Check that “TV Speakers” option is set to “On” in the “Features” |
|
|
| menu (page 22). |
|
|
|
|
|
| Audio noise. | • Make sure that the aerial is connected. |
|
|
| • Keep the aerial cable away from other connecting cables. |
|
|
| • Do not use |
|
|
| • Communication problems may occur if the infrared communication |
|
|
| equipment (e.g. infrared cordless headphones) is used near the TV. |
|
|
| Please use headphones other than infrared cordless headphones, |
|
|
| move the infrared transceiver away from the TV until the noise is |
|
|
| eliminated, or move the transmitter and receiver of the infrared |
|
|
| communication equipment closer together. |
|
|
| • Using the menu system, select “Audio Filter” from the “Manual |
|
|
| Programme Preset” menu. Next select “Low” or “High” (see page |
|
|
| 26). |
Unable to receive a stereo or dual sound • broadcast
Check that the “Audio Filter” option in the “Manual Programme Preset” menu is set to “Off”.(see page 26).
34 Additional Information