Connect the CATV cable to the VCR’s IN jack.

Installing and Connecting the TV

Connecting a VCR and Cable TV

Use this hookup if:

• You subscribe to a cable TV system that does not require a cable box.

Disconnect all power sources before making any connections.

1

2 Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack to the TV’s VHF/UHF jack.

3 Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.

Rear of TV

75-ohm

75-ohm coaxial

coaxial cable

(supplied)

cable (supplied)

 

S VIDEO

VCR

VIDEO (yellow)

 

AUDIO-L (white)

Cable

AUDIO-R

 

S VIDEO cable

(red)

 

(not supplied)

 

AUDIO cable (not supplied)

Note

When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure

“Auto YC” in the

(Setup) menu is set to “On” to view the S VIDEO input (see below).

Tips

•You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your VCR.

•If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.

When connecting both VIDEO IN and S VIDEO IN

Using the menu, you can select the jack from which the TV receives the input signal. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN) separately. The TV is factory set to receive S VIDEO input signals.

1Press TV/VIDEO repeatedly until the desired video input appears.

2Press MENU.

 

3

Press V/v to select

(Setup), then press

.

 

4

Press V/v to select “Auto YC,” then press

.

 

5

To watch the pictures input from the S VIDEO input jack:

 

 

Press V/v to select “On,” then press

.

 

 

 

To watch the pictures input from the VIDEO input jack:

 

 

Press V/v to select “Off,” then press

.

 

12

6

Press MENU to exit the menu screen.