Installing and Connecting the TV

Connecting a Satellite Receiver

Disconnect all power sources before making any connections.

1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE IN jack.

2 Using AUDIO and S VIDEO cables, connect the satellite receiver’s AUDIO and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.

Tip

•If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.

3 Connect the supplied 75-ohm coaxial cable from your cable or antenna to the TV’s VHF/UHF jack.

Rear of TV

75-ohm coaxial cable (supplied)

S VIDEO

Satellite receiver

VIDEO (yellow)

AUDIO-L (white) Satellite

antenna cable

AUDIO-R (red)

S VIDEO cable (not supplied)

AUDIO cable (not supplied)

Note

When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make

sure “Auto YC” in the (Setup) menu is set to “On” to view the S VIDEO input (see page 12).

Tips

•You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your satellite receiver.

•Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR (your VCR must be turned on).

13