Setting the Channels
After you finish connecting your TV, you can run Auto Program to set up your channels. The Auto Setup menu appears when you turn your TV on for the first time after installing it.
To skip channels, see page 22.
1
2
1 Press I (power) on the TV.
The Auto Setup menu automatically appears on the screen when you turn on the TV for the first time.
I | Auto Setup |
| |
Auto Program: | [CH+] | ||
, | |||
Exit: | |||
| First please connect | ||
| cable/antenna |
| |
|
|
| |
Installing and Connecting the TV
2 Press CH+ on the remote control or on the side panel of your TV to perform Auto Program.
When all the receivable channels are stored, the “Channel Skip/Add” menu appears.
Auto Program is set to scan cable TV channels by default. To watch VHF/UHF channels with an antenna, see “To watch VHF/UHF channels with an antenna” below.
To perform Auto Program again1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Auto Program,” then press 
.
4Press “OK.”
“Auto Program” appears and the TV starts scanning and presetting channels automatically. When all the receivable channels are stored, the “Channel Skip/Add” menu appears. Using this menu, you can start skipping unwanted channels (see “To skip channels” on page 22).
5Press MENU to exit the menu screen.
To cancel Auto ProgramWhile “Auto Program” is displayed in step 3, press MENU on the remote control.
Note
To watch cable TV channels, you have to subscribe to a cable TV company. Note that cable TV cannot be received in some areas. This TV receives
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Cable,” then press 
.
4Press V/v to select “Off,” then press 
.
5Perform steps 3 - 5 in “To perform Auto Program again” above.
Note
You cannot receive and set the cable TV channels and VHF/ UHF channels at the same time.
Tip
When you have a cable box or satellite receiver connected, the Channel Fix feature is useful. For details, see page 22.
(Continued) 21