Sony KP-FX43, KP-FX53 Troubleshooting (continued)

Troubleshooting (continued)

Symptom	Possible cause		Solutions	Page
No picture	• The power cord, antenna • Check the power cord, antenna and			6
	or VCR is not connected.	the VCR connections.
	• The projection TV is not	• Press I/1 on the remote.		15
	turned on.	• Press ! on the projection TV to turn		16
		off the projection TV for about five
No sound		seconds, then turn it on again.
Good picture	• The volume level is too	• Press 2 + to increase the volume		16
	low.	level.
	• The sound is muted.	• Press % to cancel the muting.		16
	• The broadcast signal	• Press A/B until a better sound is		26
	has a transmission	heard.
No sound	problem.
	• The sound of the right	• Press or	.	21
	picture is selected
	when TWIN pictures
	are displayed.
Dotted lines or	• There is local	• Do not use a hair dryer or other		–
stripes	interference from cars,	equipment near the projection TV.
	neon signs, hair dryers,	• Adjust the antenna direction for		–
	power generators, etc.
		minimum interference. Contact a
		Sony dealer for advice.
Double images or	• Broadcast signals are	• Use a highly directional antenna.		–
“ghosts”	reflected by nearby	• Use the fine tuning (“FINE”) function.		46
	mountains or buildings.
	• The antenna direction	• Adjust the antenna direction. Contact		–
	needs adjustment.	a Sony dealer for advice.
	• Use of a booster is	• Turn off or disconnect the booster if it		–
	inappropriate.	is in use.
No color	• The color level setting	• Display the “PICTURE” menu and select		38
	is too low.	“ADJUST” of “PICTURE MODE”, then
		adjust the “COLOR” level.
	• The color system	• Display the “SETUP” menu and		43
	setting is	check the color system (“COL SYS”)
	inappropriate.	setting (usually set this to “AUTO”).
	• The antenna direction	• Adjust the antenna direction. Contact		–
	needs adjustment.	a Sony dealer for advice.

50Additional Information