Other Information

Cannot receive higher number channels (UHF) when using an antenna

Cable stations don’t seem to work

Remote control does not operate

Cannot change channels with the remote control

The TV needs to be cleaned

Lost password for Parental Control

Cannot access other menus when using the Basic Menu

The remote control won’t work in PIP mode

￿Make sure Cable is set to OFF in the Channel Setup menu (page 26).

￿Perform Auto Program to add channels that are not presently in the memory (page 17).

￿Make sure Cable is set to ON in the Channel Setup menu (page 26).

￿Perform Auto Program to add channels that are not presently in the memory (page 17).

￿Batteries could be weak. Replace them (page 2).

￿Move the TV 3-4 feet away from fluorescent lights.

￿Make sure you have not inadvertently switched your TV from the channel 3 or 4 setting if you are using another device to change channels.

￿If you are using another device to control channels, be sure the FUNCTION button for that device has been pressed. For example, if you’re using your VCR to control channels, be sure to press the VTR/DVD FUNCTION buttons (page 15).

￿Clean the TV with a soft dry cloth. Never use strong solvents such as thinner or benzine, which might damage the finish of the cabinet.

￿In the password screen, enter the following master password: 4357. After using the master password, you must create a new password; it cannot be used to unlock currently blocked channels.

￿If you use the button to close the Basic menu, only

the Basic menu appears when you press again. To have access to the other menus, use the F button to select Advanced Menu (page 36).

￿Press the TV FUNCTION button. You may have inadvertently pressed the VTR/DVD FUNCTION button, which changes the PIP buttons to VCR mode (page 15).

41