Operating Instructions
Cable stations don’t seem to work
Remote control does not operate
Cannot change channels with the remote control
The TV needs to be cleaned
Lost password for Parental Control
Cannot access other menus when using the Basic Menu
The remote control won’t work in PIP mode
There is no window picture or it is just static
Make sure Cable is set to ON in the Channel Setup menu (page 26).
Perform Auto Program to add channels that are not presently in the memory (page 17).
Batteries could be weak. Replace them (page 2).
Move the TV
Make sure you have not inadvertently switched your TV from the channel 3 or 4 setting if you are using another device to change channels.
If you are using another device to control channels, be sure the FUNCTION button for that device has been pressed. For example, if you’re using your VCR to control channels, be sure to press the VCR/DVD FUNCTION buttons (page 15).
Clean the TV with a soft dry cloth. Never use strong solvents such as thinner or benzine, which might damage the finish of the cabinet.
In the password screen, enter the following master password: 4357. After using the master password, you must create a new password; it cannot be used to unlock currently blocked channels.
If you use the 
button to close the Basic menu, only
the Basic menu appears when you press 
again. To have access to the other menus, use the F button to select Advanced Menu (page 36).
Press the TV FUNCTION button. You may have inadvertently pressed the VCR/DVD FUNCTION button, which changes the PIP buttons to VCR mode (page 15).
Be sure your window picture is set to a video source/ channel that has a program airing.
You may be tuned to a video input with nothing connected to it. Try cycling through your video inputs using the yellow PIP TV/VIDEO button with the red dot (page 18).
PIP is not set to receive a signal from the AUX input. If you have connected a VCR, DVD or Satellite Receiver to the AUX input on the TV, it will not show in the small window picture.
42