Operating a Cable Box or Satellite Receiver
Programming the Remote Control
You can program the supplied remote control to operate a cable box or satellite receiver.
1Press CODE SET.
2Press SAT/CABLE (FUNCTION).
3Use the
4Press ENTER.
For more details on operating the cable box or satellite receiver
If the remote control doesn’t work
First, try repeating the setup procedures using the other codes listed for your equipment.
Tips z
•If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.
•If you enter a new code number, the code number you previously entered at that setting is erased.
•In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s supplied remote control.
•Whenever you remove the batteries the code numbers may revert to the factory setting.
Cable box code numbers
Manufacturer | Code |
Hamlin/Regal | 222, 223, 224, 225, 226 |
Jerrold/G. I. | 201, 202, 203, 204, 205, |
| 206, 207, 208, 218 |
Oak | 227, 228, 229 |
Panasonic | 219, 220, 221 |
Pioneer | 214, 215 |
Scientific Atlanta | 209, 210, 211 |
Tocom | 216, 217 |
Zenith | 212, 213 |
Satellite receiver code numbers
ManufacturerCode
801 (preset code for |
Refer to the operating instructions that were supplied with the equipment.
Sony | remote control) | |
| ||
General Electric | 802 | |
805 | ||
Hitachi | ||
804 | ||
Hughes | ||
803 | ||
Panasonic | ||
802, 808 | ||
RCA/PROSCAN | ||
806, 807 | ||
Toshiba | ||
|
34