CD Player

The CD tray does not rotate.

• A CD is not placed properly.

A CD will not play.

•The CD is not lying flat in the disc tray.

•The CD is dirty.

•The CD is inserted label side down.

•Moisture condensation has built up. Remove the CD and leave the system turned on for about an hour until the moisture evaporates.

Play does not start from the first track.

•The player is in Program or Shuffle Play mode. Press PLAY MODE repeatedly until “PROGRAM” or “SHUFFLE” disappear from the display.

Tape Deck

The tape does not record.

•No tape is in the cassette holder.

•The tab has been removed from the cassette (see page 45).

•The tape has reeled to the end.

The tape does not record nor play, or there is a decrease in sound level.

•The heads are dirty. Clean them (see page 45).

•The record/playback heads are magnetized. Demagnetize them (see page 45).

The tape does not erase completely.

•The record/playback heads are magnetized. Demagnetize them (see page 45).

There is excessive wow or flutter, or the sound drops out.

•The capstans or pinch rollers are dirty. Clean them (see page 45).

Noise increases or the high frequencies are missing.

•The record/playback heads are magnetized. Demagnetize them (see page 45).

Tuner

Severe hum or noise (“TUNED” or “STEREO” flashes in the display).

•Adjust the antenna.

•The signal strength is too weak. Connect an external antenna.

A stereo FM program cannot be received in stereo.

•Press STEREO/MONO so “STEREO” appears in the display.

If other problems not described above occur, reset the system as follows:

1Unplug the power cord.

2Plug the power cord back in.

3Press SPECTRUM ANALYZER, ENTER, and DISC 1 at the same time.

47