Press to confirm a selected item on the menu.
iPOWER switch and indicatorPress to turn on the power. The indicator lights in green. Press again to turn off the power.
The indicator lights in amber in power saving mode.
jStandYou can set the monitor display in 90 degrees by using the stand (see “Using the stand” on page 15).
kSpeakerThe audio signal which is selected by the input select button on the front panel is output.
When the headphones are inserted, the sound is not output.
lLINE A buttonPress to monitor the signal through the LINE A input connectors.
mLINE B buttonPress to monitor the signal through the LINE B input connectors.
nRGB/COMPONENT buttonPress to monitor the signal through the RGB/ COMPONENT input connectors.
oPress to monitor the signal from the SDI
Press to monitor the signal from the SDI
Press to operate the unit on an external sync signal through the EXT SYNC IN connector.
The EXT SYNC button works when the component/ RGB signals are input.
rSCAN select buttonYou can change the scan size of the picture. When you press the button, the scan size is changed to the normal scan (5% over scan),
Sets the aspect ratio of the picture, 4:3 or 16:9.
tMARKER buttonWhen the button is pressed, an area marker is displayed.
uBLUE ONLY buttonPress this button to eliminate the red and green signals. Only blue signal is displayed on the screen. This facilitates “chroma” and “phase” adjustments and observation of VCR noise.
Press this button to display a monochrome picture. When the button is pressed again, the monitor switches automatically to color mode.
wKEY INHIBIT indicatorWhen the key inhibit function works, the indicator lights.
For the key inhibit function, refer to “KEY INHIBIT menu” on page 29.
Using the stand
11.5û
Pull out toward rear side.
Location and Function of Parts and Controls | 15 |
|
|