4 Rest the headphones on the processor so that the headphones’ contact point meets the processor’s contact pin while making sure that the CHG indicator lights up.
It takes approx. 16 hours to fully charge the battery (the CHG indicator goes off when charging is complete).
When placing the
headphones on the processor, be sure to hold them with
both hands so that the right
and left housings are horizontal. Place the headphones vertically on the processor then tilt them back
as illustrated below.
If the CHG indicator is not litCheck if the right and left headphones are rested on the processor correctly. The indicator will not light up if the headphones’ contact point does not meet the processor’s contact pin. In this case, remove the headphones and place them on the processor again so that the indicator lights up.
To recharge the headphone battery after usePlace the headphones on the processor after you use the headphones. The CHG indicator lights up, and the DECODE MODE indicator goes off, and then charging starts.
Since the
Notes
•The processor automatically turns off while charging the batteries.
•This system is designed to charge only the supplied rechargeable batteries, type
•If dry batteries are installed, they cannot be charged.
•Do not attempt to use the supplied
•Charge in an environmental temperature of between 0˚C and 40˚C (between 32˚F and 104˚F).
Charging and usage hours| Approx. charging hours | Approx. usage time*1 |
1 hour | 1 hour and 15 minutes*3 |
16 hours*2 | 20 hours*3 |
*1 at 1 kHz, 1 mW + 1 mW output
*2 hours required to fully charge empty batteries
*3 Time stated above may vary, depending on the temperature or conditions of use.
Preparation 11GB