Display
Changing the spectrum
analyzer display
1
2 Press PUSH ENTER (or ENTER on the remote).
The last selected spectrum appears.
3 Press < or , repeatedly to select the setting you want.
The display changes as follows:
SPECTRUM 1T | t SPECTRUM 2 |
Y | Y |
SPECTRUM OFF | SPECTRUM 3 |
RR
tSPECTRUM 4 T
4 Press PUSH ENTER (or ENTER on the remote).
Adjusting the brightness
of the display
1
2 Press M or m repeatedly to select “DIMMER”, then press PUSH ENTER (ENTER on the remote).
The last selected dimmer appears.
3 Press < or , repeatedly to select the setting you want.
The display changes as follows:
t DIMMER 1 y DIMMER 2 T
tDIMMER 3T
4 Press PUSH ENTER (or ENTER on the remote).
Changing the power
illuminator
You can select the power illuminator as you want.
Press ILLUMINATION repeatedly to select the power illuminator you want when the system is turned on.
Each time you press the button, the power illuminator mode changes cyclically as follows:
PATTERN 1 t PATTERN 2 t PATTERN 3
tPATTERN 4 t PATTERN OFF
Notes
•When you turn VOLUME (or press VOL +/– on the remote), power illuminator shows the current volume level.
•During the demonstration display, you can turn on or off power illuminator by pressing
ILLUMINATION.
| Display | |
Turning off the display | ||
| ||
— Power Saving Mode |
|
The demonstration display and the clock display can be turned off to minimize the amount of power consumed during standby mode (Power Saving Mode).
Press DISPLAY repeatedly while the system is turned off until the demonstration display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY once to show the demonstration display or twice to show the clock display.
Each time you press the button, the system changes cyclically as follows:
Demonstration1) t Clock2) t Power Saving Mode
1)The display changes and the indicators flashes even when the system is turned off.
2)
continued