Sony MHC-LX10000 Specifications, 34US, Amplifier section, Disc player section, Cleaning the cabinet, Cleaning the tape heads, AUDIO POWER SPECIFICATION

Cleaning the cabinet

Clean the cabinet, panel and controls with a soft cloth slightly moistened with mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as thinner, benzene or alcohol.

To save a tape permanently

To prevent a tape from being accidentally recorded over, break off the tape tab from side A or B as illustrated.

Break off the tape tab

If you later want to reuse the tape for recording, cover the broken tab with adhesive tape.

Before placing a tape in the tape deck

Take up any slack in the tape deck. Otherwise, the tape may get entangled in the parts of the tape deck and become damaged.

When using a tape longer than 90 minutes

The tape is very elastic. Do not change the tape operations such as playback, stop and fast-winding etc. frequently. The tape may get entangled in the tape deck.

Cleaning the tape heads

Clean the tape heads after every 10 hours of use. Be sure to clean the tape heads before you start an important recording or after playing an old tape. Use a separately sold dry-type or wet-type cleaning tape. For details, refer to the instructions of the cleaning tape.

Demagnetizing the tape heads

Demagnetize the tape heads and the metal parts that have contact with the tape after every 20 to 30 hours of use with a separately sold demagnetizing tape. For details, refer to the instructions of the demagnetizing tape.

Specifications

AUDIO POWER SPECIFICATION

POWER OUTPUT AND TOTAL HARMONIC DISTORTION:

With 6-ohm loads, both channels driven, from 120 Hz – 10 kHz; rates 230 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 miliwatts to rated output.

Amplifier section

Total harmonic distortion

Less than 0.1%

(6 ohms at 1 kHz, 100 W)

Inputs

VIDEO/MD (AUDIO) IN (phono jacks): voltage 250/450 mV, impedance 47 kiloohms

TV (AUDIO) IN (phono jack):

voltage 250 mV, impedance 47 kiloohms

MIC (phone jack): sensitivity 1 mV, impedance 10 kiloohms

Outputs

PHONES (stereo mini jack):

accepts headphones of 8 ohms or more

FRONT SPEAKER: Use only the supplied speaker

SURROUND SPEAKER: Use only the supplied speaker

Disc player section

System	Compact disc and digital
	audio system
Laser	Semiconductor laser
	(λ=780 nm)
	Emission duration:
	continuous
Laser Output	Max. 44.6 ∝W*
	*This output is the value
	measured at a distance of
	200 mm from the objective
	lens surface on the Optical
	Pick-up Block with 7 mm
	aperture.
Frequency response	2 Hz – 20 kHz (±0.5 dB)
Wave length	780 – 790 nm
Signal-to-noise ratio	More than 90 dB
Dynamic range	More than 90 dB

34US