Troubleshooting

Problems and remedies

Should you encounter a problem with your system, do the following:

1Make sure the power cord and speaker cords are correctly and firmly connected.

2Find your problem in the troubleshooting checklist below and take the indicated corrective action.

If the problem persists after doing all of the above, consult your nearest Sony dealer.

General“– –:– –” appears in the display.

A power interruption has occurred. Set the clock (page 5) and timer settings (pages 14 and 15) again.

There is no sound.

Press VOL +.

Make sure the headphones are not connected.

Check the speaker connections (page 4).

Sound comes from one channel, or unbalanced left and right volume.

Place the speakers as symmetrically as possible.

Connect the supplied speakers.

There is severe hum or noise.

Move the system away from the source of noise.

Connect the system to a different wall outlet.

Install a noise filter (commercially available) to the mains line.

The timer cannot be set.

• Set the clock again (page 5).

The timer does not function.

Press CLOCK/TIMER SELECT to set the timer and light up “cDAILY” or “cREC” in the display (pages 14 and 15).

Check the timer setting and set the correct time (pages 14 and 15).

Cancel the Sleep Timer Function (page 13).

Make sure the clock is correctly set.

The color on the TV screen is irregular.

• Move the speakers farther away from the TV set.

The remote does not function.

Remove the obstacle.

Move the remote closer to the system.

Point the remote at the system’s sensor.

Replace the batteries (R6/size AA).

Locate the system away from the fluorescent light.

“PROTECT”, “PUSH” and “POWER” appear alternately.

A strong signal was input. Press ?/1 to turn off the system, leave the system turned off for a while, then press ?/1 again to turn on the system. If “PROTECT”, “PUSH” and “POWER” still appear alternately, turn off the system and check the speaker cords.

Speakers

Sound comes from only one channel, or the left and right volumes are unbalanced.

• Check the speaker connections and placement.

CD

The disc tray does not open and “LOCKED” appears.

Contact your Sony dealer or local authorized Sony service facility.

The disc tray does not close.

Place the disc correctly in the center of the tray.

Always close the tray by pressing CD Z on the unit. Trying to press the tray closed with your fingers may cause problems with the player.

The disc does not eject.

You cannot eject the disc during CD Synchro Recording. Press x to cancel the CD Synchro Recording, then press CD Z on the unit to eject the disc.

Consult your nearest Sony dealer.

Play does not start.

Open the disc tray and check whether a disc is loaded.

Wipe the disc clean (page 22).

Replace the disc.

Place the disc that this system can play.

Place the disc correctly in the center of the tray.

Place the disc in the tray with the label side up.

Remove the disc and wipe away the moisture on the disc, then leave the system turned on for a few hours until the moisture evaporates.

Press CD NX to start play.

continued

Troubleshooting

19GB