Before You Use Your Amplifier
System Speaker the Up Setting and Up Hooking
Checking the connections
After connecting all of your components to the amplifier, do the following to verify that the connections were made correctly.
?/1 | Function buttons | MASTER VOLUME | |||
VIDEO | TV | DVD | AUX | 5.1CH/SAT | MASTER VOLUME R |
?/1 |
|
|
|
|
|
SURR LEVEL SET UP |
|
|
|
|
|
– + |
|
|
|
|
|
|
|
|
| – | + |
|
|
|
|
| SOUND FIELD MODE |
1Press ?/1 to turn on the amplifier.
2Press a function button to select a component (program source) that you connected (e.g., VIDEO, TV).
3Turn on the component and start playing it.
4Rotate MASTER VOLUME to turn up the volume.
If you do not obtain normal sound output after performing this procedure, look for the reason in the checklist on this page and take the appropriate measures to correct the problem.
There is no sound no matter which component is selected.
,Check that both the amplifier and all components are turned on.
,Check that the volume level on the display is not set to VOL MIN by turning the MASTER VOLUME.
,Check that all speaker cords are connected correctly.
,Press MUTING on the remote to turn off the MUTING function.
There’s no sound from a specific component.
,Check that the component is connected correctly to audio input jacks for that component.
,Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the amplifier and the component.
If you encounter a problem that is not included above, see “Troubleshooting” on page 34.