pRear speaker height (REAR HGT.)*
Initial setting : LOW
This parameter lets you specify the height of your rear speakers for proper implementation of the Digital Cinema Sound surround modes in the “VIRTUAL” sound fields. Refer to the illustration below.
• Select “LOW” if the location of your rear speakers corresponds to section A.
• Select “HIGH” if the location of your rear speakers corresponds to section B.
This setting only affects the surround modes in the “VIRTUAL” sound fields.
B 
B
| 60 |
A | A |
| 30 |
*These parameters are not available when “Rear speaker size (REAR)“ is set to “NO”.
zAbout the rear speaker position (SIDE, and BEHIND)
This setting is designed specifically for implementation of the Digital Cinema Sound modes in the “VIRTUAL” sound fields. With the Digital Cinema Sound modes, speaker position is not as critical as other modes. All of the modes in the “VIRTUAL” sound fields were designed under the premise that the rear speaker would be located behind the listening position, but presentation remains fairly consistent even with the rear speakers positioned at a rather wide angle. However, if the speakers are pointing toward the listener from the immediate left and right of the listening position, the “VIRTUAL” sound fields will not be effective unless the rear speaker position parameter is set to “SIDE”.
Nevertheless, each listening environment has many variables, such as wall reflections, and you may obtain better results using “BEHIND” if your speakers are located high above the listening position, even if they are to the immediate left and right. Therefore, although it may result in a setting contrary to the “Rear speaker position” explanation, we recommend that you play back multi channel surround encoded software and listen to the effect each setting has on your listening environment. Choose the setting that provides a good sense of spaciousness and that best succeeds in forming a cohesive space between the surround sound from the rear speakers and the sound from the front speakers. If you are not sure which sounds best, select “BEHIND” and then use the speaker distance parameter and speaker level adjustments to obtain proper balance.
pSub woofer selection (SUB WOOFER)
Initial setting : YES
• If you connect a sub woofer, select “YES”.
• If you do not connect a sub woofer, select “NO”. This activates the bass redirection circuitry and outputs the LFE signals from other speakers.
• In order to take full advantage of the Dolby Digital
pFront speaker distance (FRONT)
Initial setting : 5.0 meter
Set the distance from your listening position to the front (left or right) speaker (A on page 15).
•Front speaker distance can be set in 0.1 meter (1 foot) steps from 1.0 to 12.0 meters (3 to 40 feet).
•If both speakers are not placed an equal distance from your listening position, set the distance to the closest speaker.
pCenter speaker distance (CENTER)
Initial setting : 5.0 meter
Set the distance from your listening position to the center speaker.
• Center speaker distance can be set in 0.1 meter (1 foot) steps from a distance equal to the front speaker distance (A on page 15) to a distance 1.5 meters (5 feet) closer to your listening position (B on page 15).
• Do not place the center speaker farther away from your listening position than the front speakers.
pRear speaker distance (REAR)
Initial setting : 3.5 meter
Set the distance from your listening position to the rear (left or right) speaker.
•Rear speaker distance can be set in 0.1 meter (1 foot) steps from a distance equal to the front speaker distance (A on page 15) to a distance 4.5 meters (15 feet) closer to your listening position (C on page 15).
•Do not place the rear speakers farther away from your listening position than the front speakers.
•If both speakers are not placed an equal distance from your listening position, set the distance to the closest speaker.
System Speaker the Up Setting and Up Hooking