To stop recording, press x.

After you press x, the recorder will automatically turn off after:

about 5 minutes when using AC power adaptor.

about 10 seconds when using batteries.

Notes

“Data Save” or “TOC Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display.

The lid does not open until “TOC Edit” disappears in the display.

To

Press

 

 

Record from the end of the

END SEARCH, and then press and

previous recording1)

slide REC.

Record partway through the

N, >or .to find the start

previous recording1)

point of recording and press xto

 

stop. Then press and slide REC.

 

 

Pause

X2)

 

Press Xagain to resume recording.

 

 

Remove the MD

xand open the lid.3) (The lid does

 

not open while “TOC Edit”

 

flashing in the display.)

 

 

1)By setting “REC-Posi” to “From End”, recording operations will always start from the end of the previously recorded material (page 28).

2)A track mark is added at the point where you press Xagain to resume recording while pausing; thus the remainder of the track will be counted as a new track.

3)If you open the lid and re-insert the same disc while “REC-Posi” is set to “From Here,” recording will continue from the point where it last ended. If you insert another disc, recording will start from the beginning of the disc. Check the point to start recording on the display.

If the recording does not start

Make sure the recorder is not locked (page 41).

Make sure the MD is not record-protected (page 61).

Premastered MDs cannot be recorded over.

For models supplied with the AC plug adaptor

If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.

15