Sony NSP-100 manual Remote Controller Preparations, Replacing the Battery

Operation

Preparations

This section describes the preparations for operating the NSP-100 with the supplied remote controller, after making the required connections (see page 24).

For details of preparations to operate the NSP-100 from a computer or through a network, refer to the Help information for the BZNP-100 Software.

Remote Controller Preparations

The remote controller is supplied with a CR2025 lithium battery and insulating film installed. Removing the insulating film allows the battery to be used.

Replacing the Battery

On the back of the remote controller, pull out the battery holder. Insert the CR2025 lithium battery with the positive side up, then return the battery holder to its original position.

Main Unit DIP Switch and Remote Controller Settings

To operate the NSP-100 with the remote controller, in the DIP switches on the rear panel of the main unit, set the third switch from the left to the 1 position (ON).

Then set the remote controller to correspond with the code number setting of the rightmost switch as follows.

When the code number is 1 (the switch is in the “1” position): Hold down the STOP and PAUSE buttons on the remote controller, then press numeric button 1.

When the code number is 2 (the switch is in the “2” position): Hold down the STOP and PAUSE buttons on the remote controller, then press numeric button 2.

Set to the “1” position (ON).

To correspond with the setting of this switch, press numeric button 1 or 2 on

1 the remote controller while holding down the STOP and PAUSE buttons.

2

When operating two NSP-100 units with a single remote controller

Set the code number to 1 on one of the NSP-100 units, and set the code number to 2 on the other unit. To switch the remote controller from one unit to the other, use the same method as above.

Operation

Preparations

9