2-4 PCS-1/1P
6. A line is not connected. (LAN)
.Check that the LAN cable is connected properly.
.Check that the left indicator (green) of the main unit’s LAN connector blinks.
.Check that the LAN indicator ( ) is highlighted in the system status display area (in the lower-right
position of the screen) of the initial screen.
.Check that an IP address is properly displayed below the LAN indicator.
.Check that the setting contents of a dial list and system setup are proper.
.Check that ping can be used for a default gateway or connection destination in the communication test
(Section 2-2) based on ping.
7. The voice from the remote side cannot be heard after line connection.
.Check that the volume of the main unit is proper.
.Check that the volume of a monitor is proper.
.Check that the audio cable of the main unit and monitor is connected properly.
.Check that the remote side is not set to MIC OFF.
.Check that the audio input on the remote side is proper. (Check that a voice is normally input using an
audio input level indicator on page 1/2 of an audio setup menu.)
8. A voice does not reach the remote side after line connection.
.Check that the volume of the main unit on the remote side is proper.
.Check that the volume of the monitor on the remote side is proper.
.Check that the audio cable of the main unit and monitor on the remote side is connected properly.
.Check that the local side is not set to MIC OFF.
.Check that the audio input on the local side is proper. (Check that a voice is normally input using an
audio input level indicator on page 1/2 of an audio setup menu.)
9. The image from the remote side is not displayed after line connection.
.Check that the video input on the remote side is selected properly.
.Check that the display can be switched using the remote/local button of a remote controller.
.Check that a local image is displayed in self-loopback (Section 2-1) without any problem.
.Check that a remote image is displayed during connection with other remote sides.
10. An image does not reach the remote side after line connection.
.Check that the video input on the local side is selected properly.
.Check that the display can be switched using the remote/local button of a remote controller on the
remote side.
.Check that a local image is displayed in self-loopback (Section 2-1) on the remote side without any
problem.
.Check that a remote image on the remote side is displayed during connection with other remote sides.